Specifications

Page 34 MultiWeigher 3000 Operations Manual
4.1.2. MultiWeigher Checkweigher Simulator
To create a Checkweigher Simulator, select the SIMCHECKWEIGHER driver in the Devices
setting. When the simulator device is enabled, a checkweigher simulator is created as
shown in the screen below.
Figure 18 - Checkweigher Simulator Screen
Before starting to run the Checkweigher Simulator, it needs to be set up.
The main fields that need to be set are the Target, LoLo, Lo, Hi, HiHi, STD, Total Counts
When filling in the main fields, the Write Mode needs to be enabled
After the setup, press the button to start the simulator. The simulator will self-run
until the Total Counts is achieved
Click on the button to clear all the totals before starting the simulator again
Click on the button to view the AQS compliancy test simulation