Specifications

MultiWeigher 3000 Operations Manual Page 31
 Average This field store the overall Average weight of the captured
checkweigher product
This field is NOT writable by the use
Average Over Last __ Minute / Samples stores the Average weight
over a period of time or over a number of samples. The numerical
number of minute and sample is writable by the user
This Average field is NOT writable by the user
 STD This field stores the Standard Deviation of the captured
checkweigher product
This field is NOT writable by the user
 STDP This field stores the Population Standard Deviation of the captured
checkweigher product
This field is NOT writable by the user
• Start Clicking on the Start button will initiate MultiWeigher to transmit the
serial start command via the connected communication method to a
particular checkweigher controller.
The checkweigher receiving this command will switch from stop mode
to run mode; all the connected conveyors and associated
equipment will run
• Stop
Clicking on the Stop button will initiate MultiWeigher to transmit the
serial stop command via the connected communication method to a
particular checkweigher controller.
The checkweigher receiving this command will switch from run mode
to stop mode; all the connected conveyors and associated equipment
will stop
• Clear Totals Clicking on the Clear Totals button will initiate MultiWeigher to
transmit serial clear totals command via the connected
communications method to a connected checkweigher controller.
There will be a short lapse in time while the checkweigher controller
writes all stored values back to zero; the MultiWeigher software
should now display all zeros in the counts and stats fields.
• Rescan Code Number The Rescan Code Numbers button allows the user to
force the software to rescan the checkweigher controller in
the field. This would normally be done to verify what is the
actual product code has been set in the controller to be
check.
If the rescan does verify that the checkweigher has been
changed to another product, the software will from now on
monitor this updated product code.