Instruction manual

4
2.1. Display
z Displays the weight data received. When the unit is “g” (gram), the unit
indicator turns on.
z When the weight value is stable (the header of the weight data received is
“ST”), the STABLE indicator turns on.
z If the AD-8923-CC does not receive the weight data for two seconds or
more, - - - - - is displayed (Bar display).
z Displays the AD-4212C weighing speed that is currently set, by turning on
the corresponding indicator.
2.2. Keys
z Operates the AD-4212C. For details, refer to “3.4. Operation”.
z To enter the function setting of the AD-8923-CC, press the CAL key while
holding down the ON:OFF key. For details, refer to “4. FUNCTION
SETTING”.)
2.3. Connectors
z RS-232C connector ...... D-Sub 9-pin (male)
Used to connect to the AD-4212C weighing unit. For details, refer to “5.
RS-232C CONNECTOR”.
z CC-Link connector ........ 5-pin (male)
Used to connect to other AD-8923-CCs, PLCs or other CC-Link devices.
For details, refer to “6. CC-Link CONNECTOR”.
z DC input terminal (24 DCV) / AC adapter input jack
Either power supply can be used. For details, refer to “3.3. Turing the
power on”.
Weighing
speed
indicators
Turns on while the AD-4212C
is in the standby mode.
STABLE indicato
r
Unit indicato
r
AD-8923
REMOTE CONTROLLER
ON:OFF
CAL
SAMPLE
PRINT
MODE
RE-ZERO
STABLE
FAST
MID.
RESPONSE
SLOW