Instruction manual

8
Cable connection
CAUTION
Before inserting the power line, make sure that the power to the
AD-8923-CC is turned off.
(1) Inserting the power line
Press down the release button on
the DC input terminal using a
screwdriver and insert the power
line.
The recommended stripping
length for the power line is 10
mm.
Applicable wire range
Single wire: φ1.0 mm (AWG 26) to φ1.2 mm (AWG 16)
Twisted wire: 0.3 mm
2
(AWG 22) to 0.75 mm
2
(AWG 20)
Individual wire diameter φ0.18 mm or greater
(2) Securing or removing the power line
To secure the power line, return the release button to the initial position
using the screwdriver. The power line will be locked.
To remove the power line, press the release button again using the
screwdriver, unlocking the power line.
When the AC adapter is used
Insert the AC adapter plug into the
AC adapter input jack located on
the rear of the AD-8923-CC and
insert the AC adapter into an
electrical outlet.
DC in
p
ut terminal
AD-8923-CC rear
Release button
Screwdrive
r
Power line
A
C ada
p
ter in
p
ut
j
ac
k
DC in
p
ut terminal
A
C adapter plug
AD-8923-CC rear