Instruction manual

10
4. FUNCTION SETTING
Function setting specifies the AD-8923-BCD performance. The parameters are
stored in non-volatile memory, and are maintained even if the power line or AC
adapter is removed.
The function setting menu consists of two layers. The first layer is the “Class”
and the second layer is the “Item”. Each item stores a parameter.
Press the SAMPLE key to select an item and press the RE-ZERO key to
change the parameter. Then, press the PRINT key to store the new
parameter.
Example
This example sets “Baud rate” to “9600 bps”.
Note
The AD-8923-BCD may not function properly, depending on the
settings and operating environment. Check the settings and change
them as necessary.
While holding
down
Item
Class
Item
"Baud rate"
Parameter
"9600 bps"
Press twice
press
END
START