Manual

Page 14 HV-WP/HW-WP Series
6.1. Display and Symbols
Display and Symbols Meaning
A
Example. Storing the unit mass of the counting mode.
The unit mass is stored, using 20 pieces of samples.
The zero value means that no articles are on the pan.
A
A
A
A
Example. Storing the unit mass of the counting mode.
The unit mass is stored, using 10 pieces of samples.
The sign "-" means "weighing value is not zero".
A
A
A
A
Example. Percentage mode.
This mode uses the registered 100% mass, and converts
the weighing value to a percentage. The unit is % .
A
A
A
A
Example. Display of the function table.
This function table sets parameters of items.
ENTER switch Selecting an item.
∧ and ＜ switches Selecting the parameter of an item.
ENTER switch Storing new parameters.
A
A
A
A
A
Example. Preset tare. Entering tare with digital input.
＜ switch Selecting a figure.
∧ switch Selecting a number.
ENTER switch Storing a new tare.
A
A
A
A
Example. Hold display
The hold display is set using f12 of the function table.
When the value is "nearly-zero" or changes more than
25% +30 digits, the hold is canceled.
A
A
A
A
Weighing error.
Check the base unit and weighing pan.
Over load display.
Remove the mass from the weighing pan.
A
A
A
A
Calibration error.
The calibration mass is too light.
Check the base unit and weighing pan.
A
A
A
A
Calibration error.
The calibration mass is too heavy.
Check the base unit and weighing pan.
A
A
A
A
The "digit" is a unit of display, and is equivalent to the minimum measurable mass.
The " nearly-zero " is within ±5 digits from zero point in the unit of kg.
Zero value20 pieces
STABLE
PT