Manual

HV-WP/HW-WP Series Page 11
5. 2. Grounding the Balance
5.2. Grounding the Scale
When using where there may be static electricity, ground the scale.
The grounding procedure depends on the scale model. Refer to the table below.
These procedures are only for grounding part of the scale.
Models Refer to
HV-15KV-WP, HW-10KV-WP
Procedure A
HV-60KV-WP, HV-200KV-WP
HW-60KV-WP, HW-100KV-WP, HW-200KV-WP
Procedure B
Procedure A
(HV-15KV-WP, HW-10KV-WP)
Secure the grounding cable using a M4 screw in the
screw hole between the two hexagon bolts on the
base unit bottom side. (Part of “ ”)
Procedure B
(HV-60KV-WP, HV-200KV-WP, HW-60KV-WP, HW-100KV-WP, HW-200KV-WP)
Secure the grounding cable using the screw that
secures the under cover. (Part of “ ”)
Base unit
bottom side
Levering feet
Under cover
Base unit
bottom side