Instruction Manual

AD-4406 Weighing Indicator Page 49
Enabling Key Switches
Enabling Key SwitchesEnabling Key Switches
Enabling Key Switches
Enables the key switches that are disabled by the DK command. Not applicable to the
keys disabled by F12.
Template EK,n
n: key switch number (0: all keys, 1 - 6: refer to F-Function F12)
Command Example: to enable all keys
Reply
13.3.3. Commands to Set Parameters
Set Limit/Setpoint Value
Set Limit/Setpoint ValueSet Limit/Setpoint Value
Set Limit/Setpoint Value
Sets the limit or setpoint value of the comparison. The decimal point is not necessary.
Template Sm,n, [ value ]
m: code memory number, 0 - 4
n : setpoint order number, refer to "Setting the setpoint"
Command
Reply
Set Zero Band
Set Zero BandSet Zero Band
Set Zero Band
Sets the F26 value (zero band) of the comparison. The decimal point is not necessary.
Template SZ, [ value ]
Command
Reply
13.3.4. Commands for Hold Function
Start Averaging to Hold
Start Averaging to HoldStart Averaging to Hold
Start Averaging to Hold
Starts averaging to hold. The reply differs with the conditions.
Template HS
Command
Reply Averaging start
Averaging now
Hold
Release the Hold Data
Release the Hold DataRelease the Hold Data
Release the Hold Data
Releases the hold data or stops averaging and goes to the normal weighing mode.
Template HC
Command
Reply
13.3. Command Format
KE 0,
KE 0,
D
H
1
,
D
H
2
,
S
H
S
H
C
H
C
H
1
S
, ,
3
1
+
0
6
1S , ,3 1+ 06
ZS , 7+ 84
ZS , 7+ 84