User`s manual

PCM-3347 User’s Manual 48
Chapter 6 PCI SVGA Setup
6.1 Introduction
The PCM-3347 has an onboard AGP flat panel/VGA interface. The spec-
ifications and features are described as follows:
6.1.1 Chipset
The PCM-3347 uses a C&T 69000 chipset for its PCI/SVGA controller. It
supports many popular LCD, EL, and gas plasma flat panel displays and
conventional analog CRT monitors. The 69000 VGA BIOS supports
monochrome LCD, EL, color TFT and STN LCD flat panel displays. In
addition, it also supports interlaced and non-interlaced analog monitors
(color and monochrome VGA) in high-resolution modes while maintain-
ing complete IBM VGA compatibility. Digital monitors (i.e. MDA, CGA,
and EGA) are NOT supported. Multiple frequency (multisync) monitors
are handled as if they were analog monitors.
6.1.2 Display memory
With onboard 2 MB display memory, the VGA controller can drive CRT
displays or color panel displays with resolutions up to 1024 x 768 at 64 K
colors.
6.1.3 Display types
CRT and panel displays can be used simultaneously. The PCM-3347 can
be set in one of three configurations: on a CRT, on a flat panel display, or
on both simultaneously. CRT and panel displays can be used simulta-
neously. The PCM-3347 can be set in one of three configurations: on a
CRT, on a flat panel display, or on both simultaneously. The system is ini-
tially set to simultaneous display mode. The utility disks includes three
*.COM files in the subdirectory Utility\vga\ which can be used to config-
ure the display. In order to use these configuration programs, type the file
name and path at the DOS prompt. CT.COM: Enables CRT display only
FP.COM: Enables panel display only SM.COM: Enables both displays
simultaneously