User`s manual

PCM-3347 User’s Manual 24
3.3 Ethernet software configuration
The PCM-3347 ís onboard Ethernet interface supports all major network
operating systems. To configure the medium type, to view the current
configuration, or to run diagnostics, do the following:
1. Power the PCM-3347 on. Make sure that the RSET8139.EXE file
is located in the working drive.
2. At the prompt, type RSET8139.EXE and press <Enter>. The Ether-
net configuration program will then be displayed.
3. This simple screen shows all the available options for the Ethernet
interface. Just highlight the option you wish to change by using the Up
and Down keys. To change a selected item, press <Enter>, and a screen
will appear with the available options. Highlight your option and press
<Enter>. Each highlighted option has a helpful message guide displayed
at the bottom of the screen for additional information.
4. After you have made your selections and are sure this is the config-
uration you want, press ESC. A prompt will appear asking if you want to
save the configuration. Press Y if you want to save.
The Ethernet Setup Menu also offers three very useful diagnostic func-
tions. These are:
1. Run EEPROM Test
2. Run Diagnostics on Board
3. Run Diagnostics on Network
20 B0 11 P2
21 B1 12 P3
22 B2 13 P4
23 B3 14 P5
24 B4 15 P6
25 B5 16 P7
26 ENAB 37 M/DE
27 GND 34 GND
28 VCC 1 +5 V
29 VCC 2 +5 V
30 GND 3 GND