User`s manual
Table Of Contents
- Contents
- Chapter 1 General Information
- Chapter 2 Introduction
- 2.1 Connectors (PCM-3348 has no LCD connectors)
- 2.2 Locating connectors
- 2.3 Installation Procedures
- 2.4 Ethernet connector (CN2) (PCM-3347F/3348F)
- 2.5 LCD-A display connector (CN7)
- 2.6 Serial ports (CN5, CN6, CN8, CN9)
- 2.7 EIDE HDD connector (CN1)
- 2.8 PC/104 connector (CN17, CN19)
- 2.9 Parallel port connector (CN12)
- 2.10 Backlight connector (CN3) PCM-3347
- 2.11 VGA connector (CN10)
- 2.12 Reset button connector (CN13)
- 2.13 Main power (+5 V / +12 V) connector (CN14)
- 2.14 PS/2 Keyboard/mouse connector (CN18)
- 2.15 5 V connector (CN16)
- 2.16 FDD connector (CN22)
- 2.17 LCD-B connector (CN11)
- 2.18 CompactFlash™ socket (CN22)
- 2.19 I2C BUS (CN4)
- 2.20 HDD LED connector (CN15)
- 2.21 SIR connector (CN20)
- Chapter 3 Software Configuration
- Chapter 4 Award BIOS Setup
- 4.1 System test and initialization
- 4.2 Award BIOS setup
- Chapter 5 SVGA Setup
- Chapter 6 PCI SVGA Setup
- Chapter 7 PCI Bus Ethernet Interface
- Appendix A Programming the Watchdog Timer
- Appendix B Installing PC/104 Modules
- Appendix C Pin Assignments
- C.1 Ethernet connector (CN2)
- C.2 LCD-A connector (CN7)
- C.3 COM1, COM3, COM4 connector (CN6, CN 9, CN8)
- C.4 COM2 connector (CN5, CN23)
- C.5 EIDE hard drive connector (CN1)
- C.6 PC/104 connector (CN17, CN19)
- C.7 Parallel port connector (CN12)
- C.8 Backlight connector (CN3)
- C.9 VGA connector (CN10)
- C.10 Reset button connector (CN13)
- C.11 Main power (+5 V) connector (CN14)
- C.12 PS/2 keyboard/mouse connector (CN18)
- C.13 5 V connector (CN16)
- C.14 FDD connector (CN22)
- C.15 LCD-B connector (CN11)
- C.16 CompactFlash™ socket (CN21)
- Appendix D System Assignments
- Appendix E LCD Services
PCM-3347 User’s Manual 4
1.3.2 VGA function (PCM-3347 only)
• Controller: C&T 69000, supports CRT and 36-bit LCD
• Display memory: 2 MB SDRAM built-in
• Display resolution: 1024 x 768 @ 16 bpp (CRT), 1024 x 768 @ 16
bpp (LCD)
Resolution Map for PCM-3347 Series
1.3.3 VGA function PCM-3348
• Display memory: 512 KB ~ 4 MB share memory, set in BIOS
• Display type: Supports CRT
• CRT display mode: Non-interlaced CRT monitors resolutions up to
1280 x 1024 @ 24 bpp
1.3.4 Ethernet function
• Chipset: RTL 8100BL
• Ethernet interface: PCI 10/100 Mbps Ethernet. IEEE 802.3u protocol
compatible
• Connection: Onboard 10-pin 2 mm connector
1.3.5 Solid state disk
• Supports CompactFlash™ cards
1.3.6 Mechanical and environmental
• Operating voltage: +5 V only
• Power consumption: +5 V @ 1.62 A (typical) @ STPC Elite 133 MHz
CPU +32 MB
• Size (L x W): 96 mm x 90 mm (3.77" x 3.54")
• Weight: 0.103 kg (0.227 lb)
• Operating temperature: 0 ~ 60° C (32 ~ 140° F)
Resolution Colors
256 64K 16M
640 x 480 OK OK OK
800 x 600 OK OK OK
1024 x 768 OK OK NG