User Manual

BadgeR+ Product Manual

Developed by 911Cellular

Charging Your Device

Each BadgeR+ is shipped with a USB-C charging cable. Plug one end of the cable into a power

source, and the other end into your BadgeR+. To see if the device is charging, press the Status /

Pairing Button.

Caring For Your Device

While the electronics are enclosed in a sturdy case, it is still important that you keep your device

away from water, as it may damage the components.

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

CAUTION: The grantee is not responsible for any changes or modifications not expressly approved

by the party responsible for compliance. Such modifications could void the user’s authority to operate

the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses,

and can radiate radio frequency energy, and if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

● Reorient or relocate the receiving antenna.

● Increase the separation between the equipment and receiver.

● Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

● Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:

This device meets the government's requirements for exposure to radio waves. The guidelines are

based on standards that were developed by independent scientific organizations through periodic and

thorough evaluation of scientific studies. The standards include a substantial safety margin designed

to assure the safety of all persons regardless of age or health. The SAR limit of USA (FCC) is 1.6

W/kg averaged. BadgerR+ (Contains FCC ID: 2A9ZA-BADGERP) has also been tested against this

SAR limit.

SAR information on this and other pad can be viewed online at

http://www.fcc.gov/oet/ea/fccid/.

Please use the device FCC ID number for search. This device was tested simulation typical 0mm to

body. To maintain compliance with FCC RF exposure requirements, use accessories should maintain