User_Manual

Setup
5
Tilt fulcrum back until the lines on top of fulcrum and arm base
line up.
Check the levelling bubble to insure that the C-Pan Arm II is
set level in all directions.
7
Place counter weights on tube. Place the weights as needed
(depending on camera weight) to reach a safe operating
balance. Weights can be set at different positions on the tube
to increase or decrease counter balance. It is important to
test the C-Pan Arm II at its maximum reach with the
camera mounted to set the right weight requirement.
9
11
Use the camera plate tilt to position the camera lens in the
middle of the two arms.
12
1. Attach the counter weight tube to the
front of the C-Pan Arm II
2. Insert the lock pin.
8
3/8’’
1/4’’
Attach camera to the camera plate.The carmera screw has a
1/4" thread on one side and 3/8" on the other
10
After every setup of the C-Pan Arm II: Double check that the arm always stays stable doing all its movements.
Do this by supporting the camera while guiding it through its initial movements into its maximum positions.
Make sure the screw is tightened enough to fix up the camera
on the platform.