Deployment Guide
# passwd
Enter new password
4.2.2 Static IP address configuration
By default, The Eyes have DHCP enabled on their Ethernet interface. In order to configure a static IP
address to an Eye:
Step 1: Connect to the Eye unit
# ssh root@<Eye IP address>
Step 2: Configure IP settings
Set the IP address of the Eye management interface. DO NOT REBOOT between configuration steps
below.
Type N to “IP configuration changed. Do you want to activate new configuration by restarting Eye services
(otherwise, the new configuration will be activated after next boot) [Y/n]?”
# 7config ip set addr <IP address>
Set the network mask of the Eye management interface:
# 7config ip set mask <dot-format-mask>
7signal Solutions Inc., 6155 Rockside Road, Suite 110, Independence, Ohio 44131, USA,
216-777-2900, info@7signal.com, www.7signal.com