Deployment Guide

log resides in the folder /nand/ as files named syslog*, in 802.11a/b/g/n in folder /var/log as files named
messages, and in 802.11a/b/g/n/ac (Eye 2100/500/2200) in folder /var/log as files named 7signal.log.
Reading of the log files is either from the chosen storage directly or with the command logread (Eye
1000/2000 only).
By default, only the critical messages are logged. Currently, the supported commands are:
● show which shows the current log configuration.
● set
o level which sets the current level of logging
o default which sets default level of logging at system start-up
o target which sets logging target, ring buffer or NAND.
Log level set by 'set level' command remains active until restart of the system. Default log level
after installation is "ERROR".
Log levels are the following:
● CRIT - Critical messages
● ERROR - Error messages
● WARN - Warning messages.
● INFO - Informational messages.
● DEBUG - Debug messages.
7signal Solutions Inc., 6155 Rockside Road, Suite 110, Independence, Ohio 44131, USA,
216-777-2900, [e-mail], www.7signal.com