Deployment Guide

Configure Eye to connect a Carat server by using DNS redirector service
# 7config conn dns set <IP address/DNS name of DNS redirector service>
10.6 Run command group
This command group contains commands for managing Eye software run-state. Currently supported
operations are to ask current status of the software, to start, stop and restart the software, activate
software version, show installed version, uninstall a software version, and to reconfigure Eye unit without
restarting it.
7config run <CMD> [ARG]
status Show status of Eye software.
start Start Eye software.
stop Stop Eye software.
restart Restart Eye software.
reconfig Reconfigure unit and restart Eye software.
show Show active software version.
list List installed software versions.
activate Activate software version.
Example: 7config run activate 02.80
Activates version 2.80
7signal Solutions Inc., 6155 Rockside Road, Suite 110, Independence, Ohio 44131, USA,
216-777-2900, [e-mail], www.7signal.com