Deployment Guide

Command group specific help can be shown with command:
7config <group> help
General help can be shown with command:
7config help
10.2 7config ip command group
This command group contains commands for configuring IP configuration of the Eye Ethernet interface.
Currently, it is possible to show the current IP configuration, set IP address, network mask and default
gateway address (or alternatively, use DHCP configuration) of the management interface. It is also
possible to take a backup from the current IP configuration, and restore the configuration from the backup.
7config ip <CMD> <ARG> [VALUE]
'set' command arguments:
addr Set IP address of management interface (eth0)
VALUE = Valid IPv4 address
mask Set netmask of IP address of management address
VALUE = Valid IPv4 netmask in dotted format
(x.x.x.x)
port Set management port
VALUE = TCP port number
7signal Solutions Inc., 6155 Rockside Road, Suite 110, Independence, Ohio 44131, USA,
216-777-2900, [e-mail], www.7signal.com