User Guide Part 2

18 7signal solution 89
7signal Solutions, Inc., 526 S. Main Street, Akron, Ohio 44311, USA, 855-763-9526, [e-mail], www.7signal.com
7signal Sapphire Carat User Guide Release 5.0
c. (UDP only): Sender (Sonar) port. Default 0 means that system shall allocate
used ports. User-given port overrides this setting. Please observe possible
firewall settings.
d. (UDP only): Receiver (Eye) port. Default 0 means that system will allocate used
ports. User-given port overrides this setting. Please observe possible firewall
settings.
e. Select the display format for the results
f. Select how many times the test is to be run
7. Select “Execute”. Test progress information can be seen in the “Test progress” area.
8. The results are displayed in a table as shown below
You can change how the test result is shown even after the test is executed.
Figure 48: TCP download test
18.9 Upload tests
This test gives an indication of an access point’s TCP uplink capacity.
1. In the Network topology, select
a. the Eye that will run the test
i. Right-click and select ”Manual tests”
ii. From the submenu select either “TCP Upload Test” or “UDP Upload
Test”
iii. Select an access point from the pull-down menu