User Guide Part 2

18 7signal solution 88
7signal Solutions, Inc., 526 S. Main Street, Akron, Ohio 44311, USA, 855-763-9526, [e-mail], www.7signal.com
7signal Sapphire Carat User Guide Release 5.0
Figure 47: Optimal antenna selection test
18.8 Download tests
This test gives an indication of an access point’s TCP or UDP downlink capacity.
1. In the Network topology, select
a. the Eye that will run the test
i. Right-click and select ”Manual tests”
ii. From the submenu select either “TCP Download Test” or “UDP
Download Test”
iii. Select an access point
b. Or an access point through which the test will be run
21
i. Right-click and select ”Manual tests”
ii. From the submenu select either “TCP Download Test” or “UDP
Download Test”
2. Specify whether you want to run the test against a Sonar or another target
3. Select the Sonar against which you want to run the test, or type another IP address
4. Select test type, WLAN or Ethernet
5. Select the Eye’s IP address (DHCP or static)
22
a. If static, enter the (1) local IP address, (2) local net mask, and (3) gateway
6. Set up the test options
a. Select the amount of data transferred at one time
b. (UDP only): Packet size to be used (small = 256, medium = 1024, large = 32768
bytes)
21
Meaningless if Ethernet test is chosen.
22
Only if WLAN test is chosen.