User Guide

5 Upgrading Sapphire 48
7signal Solutions Inc., 526 S. Main Street, Akron, Ohio 44311, USA, 855-763-9526, [e-mail],
www.7signal.com
7signal Sapphire Deployment Guide Release 5.0
5.9 Start Sapphire solution (Linux)
After all components have been upgraded, start the Carat and Analyzer servers.
Step 1: Start the Carat server:
Start the Carat server by issuing the command:
# 7carat start
The Carat server starts in couple of seconds:
7signal Sapphire Carat is not running
Starting 7signal Sapphire Carat: OK
7signal Sapphire Carat is not running
7signal Sapphire Carat is not running
7signal Sapphire Carat is running
Step 2: Start the Analyzer server:
Start the Analyzer server by issuing the command:
# 7analyzer start
The Analyzer server starts in couple of seconds:
Starting 7signal Analyzer server: 7signal Analyzer server start complete
7signal Analyzer server is not running
7signal Analyzer server is running
5.10 Eye upgrade
5.10.1 Eye upgrade (GUI)
Note: The Eye SW version numbers in these instructions may not be the one that is going to
be installed. However, the instructions are applicable to all SW versions.
Step 1: Start the Carat GUI:
Step 2: If necessary, install new software version to Carat,:
This step needs to be executed only if Carat was updated without in-bundled Eye software packages (i.e.
“full” version was not used).
Login as solution admin user.
Open the “Manage | Eye Software Management | SW repository management” view
- Select “Import”
- Browse the Eye software installer
o APU3 installers are for 802.11a/b/g/n Eyes
o APU2 installers are for 802.11a/b/g Eyes
o x86 installers are for Soft Eyes
o armv6 installers are for Micro Eyes