Setup Guide Part 1
10 7signal solution 30
7signal Solutions, Inc., 526 S. Main Street, Akron, Ohio 44311, USA, 855-763-9526, info@7signal.com, www.7signal.com
7signal Sapphire Carat User Guide Release 5.0
6. Enter Eye SSH password to password field. This enables automatic installation of
encryption certificate in the monitoring station
1
.
7. If you already know the test profile you want to use, you can select it now (for more
information on test profiles, see the section on test profiles in this user guide)
8. Enter the regional domain. The WLAN channels and possibly power options are
dependent on this setting so one should always choose the right setting
2
.
9. If an external antenna is attached to the monitoring station, it is possible to use the 8
th
beam or diversity antenna with the check-box. When selected, one must also provide
a. Antenna gain
b. Cable loss (measured or estimate)
10. Save the monitoring station settings by clicking “Save” or “Save and move to scan”
10.2.2 Adding monitoring station manually
1. In the Network topology, select the service area where you want to set up a
monitoring station (Eye)
2. Right-click the service area and select “Add Eye”
3. Enter a name for the Eye
4. Enter the Eye’s IP address
3
5. Enter a description for the Eye (optional)
6. Enter Eye SSH password to password field. This enables automatic installation of
encryption certificate in the monitoring station
4
.
7. If you already know the test profile you want to use, you can select it now (for more
information on test profiles, see the section on test profiles in this user guide)
8. Enter the regional domain. The WLAN channels and possibly power options are
dependent on this setting so one should always choose the right setting
5
.
9. If an external antenna is attached to the monitoring station, it is possible to use the 8
th
beam or diversity antenna with the check-box.
10. Save the monitoring station settings by clicking “Save” or “Save and move to scan”
10.2.3 Install monitoring station software
After clicking “Save” button, Carat checks if the monitoring station software is needed to be
updated. When installing a new Eye unit, this is usually the case. A popup-window is opened:
1
If you have already installed encryption certificate manually in the monitoring station, uncheck “Install
encryption certificate checkbox and leave the password field empty)
2
Regulatory domain cannot be changed in some countries, including United States.
3
In case of a Soft Eye installed to the same host as the Carat server, loopback address 127.0.0.1 MUST
BE USED!
4
If you have already installed encryption certificate manually in the monitoring station, uncheck “Install
encryption certificate checkbox and leave the password field empty)
5
Regulatory domain cannot be changed in some countries, including United States.