User's Manual

18 Manual tests 62
7signal Ltd, Panuntie 6, FI-00620 HELSINKI, FINLAND, [phone], [e-mail], www.7signal.com
7signal Sapphire Carat Carat User Guide Release 3.1
18.8 Download Tests
This test gives an indication of an access point’s FTP or UDP downlink capacity.
1. In the Network topology, select the Eye that will run the test
2. Right-click and select ”Manual tests”
3. From the submenu select either “FTP Download Test” or “UDP Download Test”
4. Specify whether you want to run the test against a Sonar or another target
5. Select the Sonar against which you want to run the test, or type another IP address
6. Select an access point
7. Select the Eye’s IP address (DHCP or static)
a. If static, enter the (1) local IP address, (2) local netmask, and (3) gateway
8. Set up the test options
a. Select the amount of data transferred at one time
b. (UDP only): Packet size to be used (small = 256, medium = 1024, large = 32768
bytes)
c. (UDP only): Sender (Sonar) port. Default 0 means that system shall allocate
used ports. User-given port overrides this setting. Please observe possible
firewall settings.
d. (UDP only): Receiver (Eye) port. Default 0 means that system will allocate used
ports. User-given port overrides this setting. Please observe possible firewall
settings.
e. Select the display format for the results
f. Select how many times the test is to be run
9. Select “Execute”
10. The results are displayed in a table as shown below
You can change the table type even after the test is executed.