User's Manual

18 Manual tests 54
7signal Ltd, Panuntie 6, FI-00620 HELSINKI, FINLAND, [phone], [e-mail], www.7signal.com
7signal Sapphire Carat Carat User Guide Release 3.1
18 MANUAL TESTS
Manual tests can run simultaneously with automated testing. Sapphire will perform ongoing
automated test first and then run user defined manual test. Automated test will continue after
manual test has been finished.
Manual test results will not be saved to database.
18.1 “Network Scan” test
The network scan test can also be used as a separate test outside initial deployment. The
deployment is described in the previous section of this guide.
To scan the network, do the following:
1. In the Network topology, select the Eye you want to use for scanning the network
2. Right-click and select “Network Scan”; a test window is displayed in the right pane
3. Select the test duration from the pull-down menu
4. If you want to view information about each antenna, select “Show RX level”
a. If this checkbox is selected, the results window has a separate line for each
antenna, which might make the window’s content more difficult to read
b. The system selects the best antenna automatically in any case
c. The system offers an active test for verification of the antenna selection
5. Select the scan directions – i.e., directional antennas
6. Select the channels to scan
7. Select “Scan”
8. The results are displayed in a table
MAC
hidden