User's Guide

Preface i
7signal Ltd, Panuntie 6, FI-00620 HELSINKI, FINLAND, [phone], [e-mail], www.7signal.com
7signal Sapphire Carat Carat User Guide Release 3.0
PREFACE
Document scope
This document is aimed for people that shall manage and configure 7signal Sapphire quality
tests on wlan networks. These administrators may select the target networks and stabilize the
expected the radio environment. The test pattern configuration and 7signal Sapphire system
administration are explained in this document.
This document does not describe how the software is installed and how to handle the
monitoring station. This is found in 7signal Sapphire Deployment Guide. To get guidance on
how to interpret the measurements, please turn to 7signal Sapphire Loupe User Guide.
FCC Warning
The radiated output power of the 7signal Sapphire Eye complies with the FCC RF exposure
limits. To avoid the possibility of exceeding the FCC radio frequency exposure limits, a distance
of at least 20 cm should be kept with the user and the device while operating.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device is restricted to indoor-only use for the 5150.0 – 5250.0 MHz band.
The FCC ID for 7signal Sapphire Eye is YLF-2010-08-APU2 for
IEEE802.11a/b/g
PENDING - PENDING - PENDING - PENDING - PENDING - PENDING
The FCC ID for 7signal Sapphire Eye is YLF-EYE-ABGN-APU3 for
IEEE802.11a/b/g/n
Note to the user
Any uninstructed modification to the 7signal products may result in violation of FCC
requirements, void warranty- Please check the 7signal Customer Terms that are delivered with
the product. 7signal Sapphire Eye contains for IEEE802.11a/b/g contains FCC ID NKRDCMA82
and Eye for IEEE802.11a/b/g/n contains FCC ID TV7R52HN.
In-door use restriction by FCC
Every device operating in 5150.0 – 5250.0 MHz band has similar FCC restrictions – if applicable
– as 7signal Sapphire. The regulation does not limit the value of 7signal Sapphire in any way. If
the targeted wireless environment uses this band, the wireless clients as well as access points
are to be used indoors like 7signal Sapphire.