User Guide

7 Physical Install of 7signal Sapphire Eye 19
7signal Ltd, Panuntie 6, FI-00620 HELSINKI, FINLAND, [phone], [e-mail], www.7signal.com
7signal Sapphire Deployment Guide Release 3.0
7 PHYSICAL INSTALL OF 7SIGNAL SAPPHIRE EYE
7.1 Roof Install
On top of Eye unit there are three slots for screws. Insert screws (Pan Head Stainless Screw,
DIN 7985 M5x12 ) on top of the Eye unit. For securing the screw use screwdriver on the
bottom of the screw. The head of the screw is supposed to have few millimeters of space
between the inserts on the unit top.
There shall be one install plate (pictured right below) that is mounted on roof. See the marking
‘CABLE’ on the plate and direct it as desired.
Insert the screws into the holes in the roof mounting plate. Turn the unit and feel it snatching
into the plate. The unit should not be moving in a loose manner but it moves only few
millimeters when properly mounted.
7.2 Wall Install
On top of Eye unit there are three slots for screws. Insert screw thread taps (Socket Set Screw
Cone Point, DIN 914, M5x20) on top of the Eye unit For securing the screw use hex key on the
bottom of the screw. In wall-mounting the screw does not have any head.