Assembly Instructions

Partition Extender Barrier Instruction Sheet

Components in the box :

Tools you will need :

Assembly instructions :

Completed assembly :

1. Remove all components from box.

2. Remove lock nuts from each screw. Hold on side for later use.

3. Align adjustable clamp (A) to holes on the acrylic back panel (B).

4. Adjust bolt with wingnut and washer to achieve desired thickness of the partition extender.

5. Using philips head screwdriver and pliers, fasten screws on adjustable clamp (A) to acrylic back panel (B).

6. Tighten lock nuts until clamp and back panel are locked into position of desired workplace location.

Philips Head Screwdriver Pliers

PLEASE NOTE: Quantity of adjustable clamps (A) will vary depending on size of acrylic back panel (B).

Adjustable Clamp Acrylic Back Panel

A. B.

L Bend

Wing Nut

Screw

Lock Nut

Washer

Lock Nut

Acrylic Back Panel

Adjustable Clamp

FRONT BACK

PLEASE NOTE:

“L” Bent piece of adjustable clamp can be ﬂipped

for a better ﬁt of your Partition Extender location.

Bolt

Screw