QCA4020
Table Of Contents
- Purpose of the Document
- Document History
- 1 Introduction
- 2 QCA4020 miniPCIe Layout
- 3 QCA4020 miniPCIe Pin Out
- 4 How to flash Image to QCA4020 miniPCIe
- 5 QCA4020 Pin Out
- 6 Software Tools to be Installed
- 7 Setting Up the Software Development Environment
- 8 Importing “Hello World” Application
- 9 Building “Hello World” Application
- 10 Flash the Application to the QCA4020 miniPCIe using USB
- 11 Flash the Application to the QCA4020 miniPCIe using JTAG
- 12 Connecting QCA4020 to Serial Terminal Through UART
- 13 Using Serial Terminal
- 14 QCLI Demo Application
25
QCA4020 miniPCIe Copyright © 5GHUB.US
When flashing is completed. You will see the following screen shoot with the output:
Flash Operation Completed Successfully...
Stopping GDB server....
SUCCESS: The process with PID 23756 has been terminated.
After finishing flashing the image, make sure to remove J1 & J3 on QCA4020 miniPCIe to exit JTAG mode.