LC29D
Table Of Contents
- Purpose of the Document
- Document History
- 1 Package Contents
- 2 Introduction
- 3 Typical Applications
- 4 GNSS Constellations
- 5 Augmentation System
- 6 Hardware Board and Case Diagram
- 7 Connecting using the UART or SPI
- 8 Using Serial Terminal
- 9 DR Configuration
- 10 Mounting
- 11 Dead-Reckoning Calibration
- 12 Enable Dead-Reckoning and 6-axis Sensor
- 13 Sensor Messages
- 14 Using QGNSS Tool
- 15 Using Arduino IDE
21
GNSS Board v1.0 Copyright © 5GHUB.US
You can view the sensor messages only in the GNSS tool by filtering those messages only as in this
screen-shoot:
15 Using Arduino IDE
Download the Arduino sketch for the LC29D module from the GitHub and upload it to the NB-IoT board.
Connect the UART of the GNSS board to the UART of the NB-IoT board. You shall see the GNSS output
messages on Arduino serial monitor.