LC29D
Table Of Contents
- Purpose of the Document
- Document History
- 1 Package Contents
- 2 Introduction
- 3 Typical Applications
- 4 GNSS Constellations
- 5 Augmentation System
- 6 Hardware Board and Case Diagram
- 7 Connecting using the UART or SPI
- 8 Using Serial Terminal
- 9 DR Configuration
- 10 Mounting
- 11 Dead-Reckoning Calibration
- 12 Enable Dead-Reckoning and 6-axis Sensor
- 13 Sensor Messages
- 14 Using QGNSS Tool
- 15 Using Arduino IDE
12
GNSS Board v1.0 Copyright © 5GHUB.US
8 Using Serial Terminal
You can use any serial monitor such as the Tera Term tool as the serial terminal. You can download it
from here:
https://osdn.net/projects/ttssh2/downloads/54081/teraterm-4.72.exe/
Launch Tera Terminal and select the Serial option and select USB-to-Serial port.
In Tera Term, choose Setup->Serial port and configure serial ports according to the following: