LC29D
Table Of Contents
- Purpose of the Document
- Document History
- 1 Package Contents
- 2 Introduction
- 3 Typical Applications
- 4 GNSS Constellations
- 5 Augmentation System
- 6 Hardware Board and Case Diagram
- 7 Connecting using the UART or SPI
- 8 Using Serial Terminal
- 9 DR Configuration
- 10 Mounting
- 11 Dead-Reckoning Calibration
- 12 Enable Dead-Reckoning and 6-axis Sensor
- 13 Sensor Messages
- 14 Using QGNSS Tool
- 15 Using Arduino IDE
11
GNSS Board v1.0 Copyright © 5GHUB.US
You can use the GNSS board with any device that has UART (Tx/Rx) interface such as an Arduino board
or any other hardware board available.
You can also use and connect the GNSS board to a USB port in the computer through a USB-to-
UART cable. You can use cable such as this one:
USB TO UART TTL (Wires) Serial Cable (PL2303HX) MCP00102W Programmer Arduino Compatible in
Elecrow bazaar!
Such a cable has four wires colored as follow:
Red: +5V (Do not Connect to the GNSS board)
White: TXD
Green: RXD
Black: GND
Connect the White cable to UART(TXD) and Green cable to UART(RXD). Also connect the Black cable to
the GND. Make sure when you connect the USB-to-UART cable, it shows correctly in Windows device
manager and all its driver is installed as in this screenshot.