User Guide

A/C Unit More Than 5 Years Old?

Compressor Hard to Start?

Lights Dim When the A/C Comes On?

Computers Restart On Their Own?

Low Voltage Situation?

Old Wiring?

TV Screen Flip Flop?

Circuit Breakers Trip?

Starting up is the hardest time in the life of any type of electrical equipment. Ever notice that light bulbs

almost always burn out when you first turn them on and not while they are on? This is due to the huge

current that rushes in whenever a switch is thrown and power is first applied.

The compressor on your Air Conditioner consumes more power on start up than any other device in your

home. A compressor may consume 45,000 watts of power while the motor is trying to start-TEN times

more power than it uses while running. In-rush current can damage the compressor’s motor and that

motor may start up more than 10,000 times in a single cooling season.

A 5-2-1

COMPRESSOR SAVER

significantly reduces the amount of time your compressor is on start-up

overload. Most top-of-the-line A/C units come from the factory with 5-2-1

technology built in. Now you

can have a 5-2-1

installed in your A/C unit by a professional.

The 5-2-1

uses a powerful multi-layer starting capacitor and a smart switch to give your compressor the

boost it needs to start up quickly, more reliably, draw less power and save you money too.

The cost of a 5-2-1

is a fraction of the cost of replacing a compressor

damaged by hard starts. It could add years to the life of your compressor.

Ask your A/C technician about a special offer on a 5-2-1

installation!

Scan our QR codes to view videos and learn more about the

5-2-1

COMPRESSOR SAVER

atch How It W

orks

PAGE 1
Old Wiring? TV Screen Flip Flop? Circuit Breakers Trip? Low Voltage Situation? Compressor Hard to Start? A/C Unit More Than 5 Years Old? Computers Restart On Their Own? Lights Dim When the A/C Comes On? Starting up is the hardest time in the life of any type of electrical equipment. Ever notice that light bulbs almost always burn out when you first turn them on and not while they are on? This is due to the huge current that rushes in whenever a switch is thrown and power is first applied.
PAGE 2
GENERAL SAFETY INSTRUCTIONS Only trained and qualified service personnel should install this kit. Most states, countries etc. may require the installer to be licensed. Please check with your local government agency. DANGER - ELECTRICAL SHOCK HAZARD - always disconnect the power source before attempting to install this kit. Failure to do so may result in severe electrical injury or even death.