User's Manual

Maintenance | 223
Aprisa SR User Manual
Single Radio Software Upgrade
The software upgrade procedure is different for an Aprisa SR Protected Station (see ‘Protected Station
Software Upgrade’ on page 35).
Note: If a radio has been configured for a Protection Type of ‘Redundant’ (see ‘Protected Station:
Terminal > Operating Mode’ on page 178), and that radio is no longer part of a Protected Station, the
Protection Type must be changed to ‘None’ before the radio software upgrade can be achieved.
File Transfer Method
This process allows customers to upgrade a single Aprisa SR radio.
The Software Pack is loaded into the radio with the file transfer process (see ‘Software > File Transfer’ on
page 156) and activated (see ‘Software > Manager’ on page 159).
Upgrade Process
The Aprisa SR upgrade operation is indicated by a flashing orange AUX LED.
To upgrade the Aprisa SR radio software:
1. Unzip the software release files in to the root directory of a USB flash drive.
2. Check that the SuperVisor USB Boot Upgrade setting is set to ‘Disabled’ (see ‘Software > Setup’ on
page 155).
3. Insert the USB flash drive into the Host Port .
4. Using File Transfer, load the software pack into the radio (see ‘Software > File Transfer’ on page 156).
5. Activate the software on the radio (see ‘Software > Manager’ on page 159).