User's Manual

ManualsBrands4RF ManualsElectronicsPOINT TO POINT DIGITAL RADIO SYSTEM (RECEIVER)

Table Of Contents

1. Getting started
2. Introduction
- About this manual
- What's in the box
  - Aprisa CD contents
  - Accessory kit
3. Preparation
- Path planning
- Site requirements
4. About the terminal
- Introduction
- Modules
- Front panel connections and indicators
- Interface card types
5. Mounting and installing the terminal
- Required tools
- Installing the terminal
- Installing the antenna and feeder cable
- External alarms
  - Alarm circuit setup
- Interface cabling
- Power supplies
- Bench setup
6. Connecting to the terminal
- Connecting to the terminal's setup port
  - Cable pinouts (RJ-45 to DB-9)
    - Configure the PC COM port settings
    - Start a HyperTerminal session
- Connecting to the terminal's ethernet interface
  - PC requirements for SuperVisor
  - PC settings for SuperVisor
- IP addressing of terminals
- Network IP addressing
  - Same subnet as local PC
  - Different subnet as local PC
7. Managing the terminal
- The setup menu
  - To get or set the IP address of a terminal using setup
- 4RF SuperVisor
  - Logging in
  - Logging out
- SuperVisor opening page
  - SuperVisor terminal status and menu bar
    - SuperVisor summary bar
- Changing the terminal’s IP address
- Setting up users
8. Configuring the terminal
- Configuring the RF settings
- Entering terminal information
  - Terminal Information
- Configuring the IP settings
- Saving the terminal's configuration
- SNMP (Simple Network Management Protocol)
- Setting the terminal clock sources
- Configuring the RSSI alarm threshold
- Configuring the external alarms
  - Configuring the external alarm inputs
  - Configuring the external alarm outputs
9. Configuring the traffic interfaces
- Viewing a summary of the interfaces
- Configuring the traffic interfaces
- Ethernet
- QJET port settings
- Q4EM port settings
- DFXO / DFXS loop interface circuits
  - DFXS port settings
  - DFXO port settings
- QV24 port settings
- HSS port settings
- HSS handshaking and clocking
  - HSS handshaking and control line function
  - HSS synchronous clock selection modes
10. Cross Connections
- Embedded cross connect switch
  - Link Capacity Utilization
- The Cross Connections application
- Configuring the traffic cross connections
- Cross connection example
- Symmetrical Connection Wizard
11. Protected terminals
- Monitored Hot Stand By (MHSB)
12. In-service commissioning
- What you will need
13. Maintenance
- Upgrade process
14. Troubleshooting
- RF radio loopback
15. Interface connections
- E&M Signalling types
  - Synchronous cable assemblies
  - Cable WAN connectors
16. Alarm types and sources
- Transmitter alarms
17. Country specific settings
18. Specifications
- Ethernet interface
19. Product end of life
20. Abbreviations
21. Acknowledgments and licensing
22. Commissioning Forms
23. Index

Maintenance | 181

To clear your web browser cache (Internet Explorer 6.x and above):

1. Select Tools > Internet Options.

2. On the General tab, click Delete Files, and then click OK to confirm.