User's Manual
Table Of Contents
- 1. Getting started
- 2. Introduction
- 3. Preparation
- 4. About the terminal
- 5. Mounting and installing the terminal
- 6. Connecting to the terminal
- 7. Managing the terminal
- 8. Configuring the terminal
- 9. Configuring the traffic interfaces
- 10. Cross Connections
- Embedded cross connect switch
- The Cross Connections application
- The Cross Connections system requirements
- Installing the Cross Connections application
- Opening the Cross Connections application
- The Cross Connections page
- Setting the terminal's address
- Management and user ethernet capacity
- Setting card types
- Getting cross connection configuration from the terminals
- Creating cross connections
- Sending cross connection configuration to the terminals
- Saving cross connection configurations
- Using existing cross connection configurations
- Printing the cross connection configuration
- Deleting cross connections
- Configuring the traffic cross connections
- Cross connection example
- Symmetrical Connection Wizard
- 11. Protected terminals
- 12. In-service commissioning
- What you will need
- Checking the antenna polarization
- Visually aligning antennas
- Accurately aligning the antennas
- Synchronizing the terminals
- Checking performance
- Checking the receive input level
- Checking the fade margin
- Checking long-term BER
- Bit Error Rate tests
- Additional tests
- Checking the link performance
- Viewing a summary of the link performance
- What you will need
- 13. Maintenance
- 14. Troubleshooting
- 15. Interface connections
- 16. Alarm types and sources
- 17. Country specific settings
- 18. Specifications
- Ethernet interface
- QJET Quad E1 / T1 interface
- Q4EM Quad 4 wire E&M interface
- DFXO Dual foreign exchange office interface
- DFXS Dual foreign exchange subscriber interface
- QV24 Quad V.24 asynchronous data interface
- HSS Single high speed synchronous data interface
- External alarm interfaces
- Auxiliary interfaces
- AC Power supply
- DC Power supply
- Power consumption
- MHSB protection
- Ethernet interface
- 19. Product end of life
- 20. Abbreviations
- 21. Acknowledgments and licensing
- 22. Commissioning Forms
- 23. Index
Index | 270
configuring............................................... 196
terminal...................................................... 28
SNMP ............................................................. 67
MIB details................................................. 70
setting access controls.............................. 68
setting trap destinations ............................ 69
viewing traps ............................................. 70
specifications................................................ 237
auxiliary interfaces................................... 251
DFXO interface........................................ 246
DFXS interface........................................ 248
environmental.......................................... 253
ethernet interface .................................... 244
ETSI ........................................................ 253
external alarms interface......................... 251
frequency bands...................................... 237
general .................................................... 253
HSS interface .......................................... 250
mechanical .............................................. 253
MHSB ...................................................... 253
power....................................................... 252
Q4EM interface ....................................... 245
QJET interface ........................................ 244
QV24 interface ........................................ 250
system performance................................ 238
standby mode............................................... 155
static damage, avoiding................................ 194
storage temperature ....................................... 23
subnet mask
factory default............................................ 56
subscriber end ................................................ 94
SuperVisor...................................................... 53
logging into ................................................ 54
logging out................................................. 54
opening page............................................. 55
PC requirements for .................................. 43
PC settings for........................................... 44
Surveyor ......................................................... 19
syslog ........................................................... 207
error logging ............................................ 207
remote logging......................................... 209
T
T1
alarm conditions ...................................... 206
framed ..................................... 135, 137, 138
unframed ................................................. 135
temperature .................................................... 23
terminal
alarm summary ....................................... 199
applying power........................................ 164
clocking ..................................................... 71
earthing ......................................... 24, 36, 37
installing .................................................... 29
logging into................................................ 54
logging out................................................. 54
modules..................................................... 26
near and far, explained ............................. 47
operating conditions.................................. 23
power supplies .......................................... 32
rebooting ................................................. 189
synchronizing .......................................... 169
upgrading ........................................ 177, 182
terminal emulator ........................................... 66
test equipment.............................................. 172
TFTP server ................................................. 177
timed reboot ................................................. 189
timeslots
PCM modes ............................................ 136
selecting.................................................. 139
tools................................................................ 29
traffic direction of interfaces ......................... 211
tranformer, Balun ......................................... 212
transmitter ...................................................... 26
tributary switch
front panel ............................................... 154
LEDs ....................................................... 155
slaves ...................................................... 156
troubleshooting............................................. 197
U
unframed mode ............................................ 135
upgrading the terminal
uploading system files............................. 182
using TFTP server .................................. 177
user ethernet capacity.................................. 125
users
access rights ............................................. 57
adding ....................................................... 57
changing passwords ................................. 59
deleting...................................................... 58
disabling.................................................... 58
reset to defaults ........................................ 66
saving user information............................. 58
session details .......................................... 59
user groups ............................................... 57
view user group......................................... 57
V
V.24
asynchronous data.................................. 108
synchronous data.................................... 109
V.35 / V.36 ................................................... 109