User's Manual
Table Of Contents
- 1. Getting started
- 2. Introduction
- 3. Preparation
- 4. About the terminal
- 5. Mounting and installing the terminal
- 6. Connecting to the terminal
- 7. Managing the terminal
- 8. Configuring the terminal
- 9. Configuring the traffic interfaces
- 10. Cross Connections
- Embedded cross connect switch
- The Cross Connections application
- The Cross Connections system requirements
- Installing the Cross Connections application
- Opening the Cross Connections application
- The Cross Connections page
- Setting the terminal's address
- Management and user ethernet capacity
- Setting card types
- Getting cross connection configuration from the terminals
- Creating cross connections
- Sending cross connection configuration to the terminals
- Saving cross connection configurations
- Using existing cross connection configurations
- Printing the cross connection configuration
- Deleting cross connections
- Configuring the traffic cross connections
- Cross connection example
- Symmetrical Connection Wizard
- 11. Protected terminals
- 12. In-service commissioning
- What you will need
- Checking the antenna polarization
- Visually aligning antennas
- Accurately aligning the antennas
- Synchronizing the terminals
- Checking performance
- Checking the receive input level
- Checking the fade margin
- Checking long-term BER
- Bit Error Rate tests
- Additional tests
- Checking the link performance
- Viewing a summary of the link performance
- What you will need
- 13. Maintenance
- 14. Troubleshooting
- 15. Interface connections
- 16. Alarm types and sources
- 17. Country specific settings
- 18. Specifications
- Ethernet interface
- QJET Quad E1 / T1 interface
- Q4EM Quad 4 wire E&M interface
- DFXO Dual foreign exchange office interface
- DFXS Dual foreign exchange subscriber interface
- QV24 Quad V.24 asynchronous data interface
- HSS Single high speed synchronous data interface
- External alarm interfaces
- Auxiliary interfaces
- AC Power supply
- DC Power supply
- Power consumption
- MHSB protection
- Ethernet interface
- 19. Product end of life
- 20. Abbreviations
- 21. Acknowledgments and licensing
- 22. Commissioning Forms
- 23. Index
Index | 268
alarm conditions ...................................... 206
framed ............................................. 135, 136
unframed ................................................. 135
earthing............................................... 22, 24, 37
EIA-530......................................................... 109
environmental requirements........................... 23
error counters ............................................... 171
Ethernet
capacity ................................................... 125
port status.................................................. 86
Quality of Service ...................................... 82
VLAN tagging ............................................ 80
exchange end............................................... 101
external alarms
configuring................................................. 74
inputs......................................................... 74
mapping..................................................... 76
outputs....................................................... 76
F
fade margin................................................... 170
fault finding ................................... 169, 197, 207
feeder cables.................................................. 22
framed mode ................................................ 135
framed modes
PCM30C mode........................................ 136
PCM31C mode........................................ 136
T1 ESF 16 mode ..................................... 138
T1 ESF 4mode ........................................ 138
T1 ESF mode .......................................... 137
T1 SF 4 mode.......................................... 137
T1 SF mode............................................. 137
frequency bands..................................... 25, 237
front panel
connections ............................................... 27
indicators ................................................... 27
RF protection switch................................ 155
tributary switch ........................................ 154
G
gateway
factory default............................................ 56
H
handshaking
DCD mode............................................... 113
DSR DTR mode ...................................... 112
RTS CTS mode ....................................... 111
hardware
accessory kit.............................................. 17
installing .............................................. 29, 30
hot stand-by.................................................. 153
HSS clocking
clocking types ......................................... 115
cloud mode ............................................. 119
internal clocking ...................................... 115
pass-through clocking............................. 115
pipe mode ............................................... 116
primary/secondary master clocking ........ 115
synchronous clock selection modes ....... 114
HSS interface card....................................... 109
cross connections for .............................. 146
handshaking............................................ 111
interface connections for......................... 219
port settings for ....................................... 109
humidity.......................................................... 23
I
image files .................................................... 184
updating table of ..................................... 188
in-service commissioning............................. 163
installation ................................................ 29, 31
interface cabling ............................................. 32
interface cards
before installing....................................... 192
configuring................................................. 79
installing .................................................. 194
port settings .............................................. 79
summary ................................................... 77
types.......................................................... 28
interface connections ................................... 211
DFXO ...................................................... 218
DFXS....................................................... 217
Ethernet................................................... 213
HSS......................................................... 219
Q4EM...................................................... 214
QJET....................................................... 212
QV24....................................................... 228
interface pinouts
HSS......................................................... 219
interface traffic direction............................... 211
interfaces, compatibility................................ 133
IP address
factory defaults.......................................... 56
for protected terminals ............................ 158
network...................................................... 48
terminal ..................................................... 65
understanding ........................................... 47
J
Java
clearing cache......................................... 179
requirement for............................ 16, 43, 121
L
LEDs