User's Manual
Table Of Contents
- 1. Getting started
- 2. Introduction
- 3. Preparation
- 4. About the terminal
- 5. Mounting and installing the terminal
- 6. Connecting to the terminal
- 7. Managing the terminal
- 8. Configuring the terminal
- 9. Configuring the traffic interfaces
- 10. Cross Connections
- Embedded cross connect switch
- The Cross Connections application
- The Cross Connections system requirements
- Installing the Cross Connections application
- Opening the Cross Connections application
- The Cross Connections page
- Setting the terminal's address
- Management and user ethernet capacity
- Setting card types
- Getting cross connection configuration from the terminals
- Creating cross connections
- Sending cross connection configuration to the terminals
- Saving cross connection configurations
- Using existing cross connection configurations
- Printing the cross connection configuration
- Deleting cross connections
- Configuring the traffic cross connections
- Cross connection example
- Symmetrical Connection Wizard
- 11. Protected terminals
- 12. In-service commissioning
- What you will need
- Checking the antenna polarization
- Visually aligning antennas
- Accurately aligning the antennas
- Synchronizing the terminals
- Checking performance
- Checking the receive input level
- Checking the fade margin
- Checking long-term BER
- Bit Error Rate tests
- Additional tests
- Checking the link performance
- Viewing a summary of the link performance
- What you will need
- 13. Maintenance
- 14. Troubleshooting
- 15. Interface connections
- 16. Alarm types and sources
- 17. Country specific settings
- 18. Specifications
- Ethernet interface
- QJET Quad E1 / T1 interface
- Q4EM Quad 4 wire E&M interface
- DFXO Dual foreign exchange office interface
- DFXS Dual foreign exchange subscriber interface
- QV24 Quad V.24 asynchronous data interface
- HSS Single high speed synchronous data interface
- External alarm interfaces
- Auxiliary interfaces
- AC Power supply
- DC Power supply
- Power consumption
- MHSB protection
- Ethernet interface
- 19. Product end of life
- 20. Abbreviations
- 21. Acknowledgments and licensing
- 22. Commissioning Forms
- 23. Index
Specifications | 237
18. Specifications
RF specifications
Frequency Bands
ETSI
R1
Frequency
Band
Frequency
Band Limits
Synthesizer
Step Size
300 MHz band 330 - 400 MHz 6.25 kHz
400 MHz band 400 - 470 MHz 6.25 kHz
600 MHz band 620 - 715 MHz 12.5 kHz
700 MHz band 698 - 806 MHz 25 kHz
800 MHz band 805 - 890 MHz 25 kHz
900 MHz band 850 - 960 MHz 25 kHz
1400 MHz band 1350 - 1550 MHz 12.5 kHz
2000 MHz band 1900 - 2300 MHz 62.5 kHz
2500 MHz band 2300 - 2700 MHz 62.5 kHz
Frequency Bands
FCC
R1
Frequency
Band
Frequency
Band Limits
Synthesizer
Step Size
400 MHz band 330 - 512 MHz 6.25 kHz
900 MHz band 850 - 960 MHz 25 kHz
Modulation
Frequency stability
Antenna connector
Note R1 Contact 4RF for other frequency options
16 / 32 / 64 QAM and QPSK (software configurable)
±3 ppm
N-type fem ale 50 Ω