User's Manual
Table Of Contents
- 1. Getting started
- 2. Introduction
- 3. Preparation
- 4. About the terminal
- 5. Mounting and installing the terminal
- 6. Connecting to the terminal
- 7. Managing the terminal
- 8. Configuring the terminal
- 9. Configuring the traffic interfaces
- 10. Cross Connections
- Embedded cross connect switch
- The Cross Connections application
- The Cross Connections system requirements
- Installing the Cross Connections application
- Opening the Cross Connections application
- The Cross Connections page
- Setting the terminal's address
- Management and user ethernet capacity
- Setting card types
- Getting cross connection configuration from the terminals
- Creating cross connections
- Sending cross connection configuration to the terminals
- Saving cross connection configurations
- Using existing cross connection configurations
- Printing the cross connection configuration
- Deleting cross connections
- Configuring the traffic cross connections
Configuring the traffic interfaces | 77
9. Configuring the traffic interfaces
Important: When configuring a link, it is important that you configure the remote terminal first as the
new configuration may break the management connection to the remote terminal.
Once the remote terminal has been configured, the local terminal should be configured to match the
remote terminal.
Viewing a summary of the interfaces
To view a summary of the interfaces fitted:
Select Link or Local or Remote > Interface > Interface Summary.
The Interface Summary page shows: