User's Manual
Table Of Contents
- 1. Getting started
- 2. Introduction
- 3. Preparation
- 4. About the terminal
- 5. Mounting and installing the terminal
- 6. Connecting to the terminal
- 7. Managing the terminal
- 8. Configuring the terminal
- 9. Configuring the traffic interfaces
- 10. Cross Connections
- Embedded cross connect switch
- The Cross Connections application
- The Cross Connections system requirements
- Installing the Cross Connections application
- Opening the Cross Connections application
- The Cross Connections page
- Setting the terminal's address
- Management and user ethernet capacity
- Setting card types
- Getting cross connection configuration from the terminals
- Creating cross connections
- Sending cross connection configuration to the terminals
- Saving cross connection configurations
- Using existing cross connection configurations
- Printing the cross connection configuration
- Deleting cross connections
- Configuring the traffic cross connections
Configuring the terminal | 61
8. Configuring the terminal
Configuring the RF settings
The RF settings are factory-configured before dispatch to the customer requirements. However, you
can change the RF settings, if required.
Select Link or Local or Remote > Terminal > Basic:
Note: Transmit frequency, transmit power, channel size, modulation and antenna polarization would
normally be defined by a local regulatory body and licensed to a particular user.
Refer to your site license details when setting these fields.