User's Manual
Table Of Contents
- 1. Getting started
- 2. Introduction
- 3. Preparation
- 4. About the terminal
- 5. Mounting and installing the terminal
- 6. Connecting to the terminal
- 7. Managing the terminal
- 8. Configuring the terminal
- 9. Configuring the traffic interfaces
- 10. Cross Connections
- Embedded cross connect switch
- The Cross Connections application
- The Cross Connections system requirements
- Installing the Cross Connections application
- Opening the Cross Connections application
- The Cross Connections page
- Setting the terminal's address
- Management and user ethernet capacity
- Setting card types
- Getting cross connection configuration from the terminals
- Creating cross connections
- Sending cross connection configuration to the terminals
- Saving cross connection configurations
- Using existing cross connection configurations
- Printing the cross connection configuration
- Deleting cross connections
- Configuring the traffic cross connections
Connecting to the terminal | 43
PC requirements for SuperVisor
SuperVisor requires the following minimum PC requirements:
Microsoft Windows 95/98, 2000, NT or XP
Personal computer with 800 MHz Pentium III
128 MB of RAM (the Java plug-in requires at least 32 MB of physical RAM)
108 MB of free hard disk space
Ethernet interface (Local Area Network)
COM port
Web browser with a Java plug-in such as Mozilla FireFox (recommended), Microsoft Internet
Explorer 5.0, or Netscape Navigator 6.0, but SuperVisor also supports other major web
browsers.
Java JRE 1.5.
Note: Mozilla Firefox, Internet Explorer and the Java JRE are provided on the Aprisa CD (see "
5Aprisa
CD contents” on page 16)