User's Manual
Table Of Contents
- 1. Getting started
- 2. Introduction
- 3. Preparation
- 4. About the terminal
- 5. Mounting and installing the terminal
- 6. Connecting to the terminal
- 7. Managing the terminal
- 8. Configuring the terminal
- 9. Configuring the traffic interfaces
- 10. Cross Connections
- Embedded cross connect switch
- The Cross Connections application
- The Cross Connections system requirements
- Installing the Cross Connections application
- Opening the Cross Connections application
- The Cross Connections page
- Setting the terminal's address
- Management and user ethernet capacity
- Setting card types
- Getting cross connection configuration from the terminals
- Creating cross connections
- Sending cross connection configuration to the terminals
- Saving cross connection configurations
- Using existing cross connection configurations
- Printing the cross connection configuration
- Deleting cross connections
- Configuring the traffic cross connections
About the terminal | 28
Interface card types
Each terminal has eight interface slots labeled A to H. Each slot can be fitted with any interface card
type. Typically, the terminal is delivered pre-configured with the requested interface cards.
The following interface card types are currently available:
Name Interface card type Function
QJET Quad E1/T1 interface card Four E1 / T1 interfaces (Framed or Unframed).
Q4EM Quad 4 wire E&M interface card Four 4 wire E&M voice channels
DFXS Dual 2 wire FXS interface card Two 2 wire loop signalling foreign exchange
subscriber (POTS) channels
DFXO Dual 2 wire FXO interface card Two 2 wire loop signalling foreign exchange office
channels
HSS High-Speed Synchronous
interface card
A single high speed serial data channel configured
as synchronous V.24, V.35, X.21, V.36 / RS 449,
or EIA/TIA 530.
QV24 Quad V.24 serial asynchronous
interface card
Four asynchronous V.24/RS232 data channels.