User's Manual
Table Of Contents
- 1. Getting started
- 2. Introduction
- 3. Preparation
- 4. About the terminal
- 5. Mounting and installing the terminal
- 6. Connecting to the terminal
- 7. Managing the terminal
- 8. Configuring the terminal
- 9. Configuring the traffic interfaces
- 10. Cross Connections
- Embedded cross connect switch
- The Cross Connections application
- The Cross Connections system requirements
- Installing the Cross Connections application
- Opening the Cross Connections application
- The Cross Connections page
- Setting the terminal's address
- Management and user ethernet capacity
- Setting card types
- Getting cross connection configuration from the terminals
- Creating cross connections
- Sending cross connection configuration to the terminals
- Saving cross connection configurations
- Using existing cross connection configurations
- Printing the cross connection configuration
- Deleting cross connections
- Configuring the traffic cross connections
About the terminal | 27
Front panel connections and indicators
All connections to the terminal are made on the front panel of the terminal.
No. Label Description
1 AC or DC power input DC and AC power supplies are available (AC is shown)
2 Safety earth stud An M5 stud for connection to an external protection ground for
protection against electric shock in case of a fault.
3 Antenna connector N-type 50 female connector for connection of antenna feeder
cable.
4 Interface slots A to H Eight interface slots on the motherboard to fit interface cards.
5 ETHERNET Integrated four-port layer 2 switch.
6 SETUP RJ-45 serial connection to PC for initial configuration.
7 ALARM RJ-45 connector for two external alarm input and four external
alarm output connections.
8 LED indicators
OK Indicates normal operation and minor and major alarm
conditions.
RX Indicates status of receive path including normal operation and
alarms such as BER, RSSI and loss of synchronization.
TX Indicates status of transmit path including normal operation and
alarms such as forward / reverse power and temperature.
ON Blue LED indicates that there is power to the terminal.
9 RSSI RSSI test point suitable for 2 mm diameter multimeter test lead
pin.