User's Manual
Table Of Contents
- 1. Getting started
- 2. Introduction
- 3. Preparation
- 4. About the terminal
- 5. Mounting and installing the terminal
- 6. Connecting to the terminal
- 7. Managing the terminal
- 8. Configuring the terminal
- 9. Configuring the traffic interfaces
- 10. Cross Connections
- Embedded cross connect switch
- The Cross Connections application
- The Cross Connections system requirements
- Installing the Cross Connections application
- Opening the Cross Connections application
- The Cross Connections page
- Setting the terminal's address
- Management and user ethernet capacity
- Setting card types
- Getting cross connection configuration from the terminals
- Creating cross connections
- Sending cross connection configuration to the terminals
- Saving cross connection configurations
- Using existing cross connection configurations
- Printing the cross connection configuration
- Deleting cross connections
- Configuring the traffic cross connections
Configuring the traffic interfaces | 107
15. The DFXO Signalling Advanced options are used to control the four CAS bits ABCD in the DFXO
to DFXS direction of transmission and one CAS bit A in the DFXS to DFXO direction of
transmission. This option sets the signalling for both
DFXO card ports.
Transparent Normal mode is used for normal traffic and Transparent Inverted mode can be used
for special signalling requirements when a function needs to be reversed e.g. to change the idle
polarity of the DFXS line feed voltage.
Forced modes are used to disable particular functions e.g. when polarity reversals are not
required. They can also be used for system testing e.g. to apply DFXO continuous off hook
Selection Description
Transparent Normal Normal transparent transmission of the CAS bit Default
Transparent
Inverted
Transparent transmission of the CAS bit but inverts the
polarity.
Forced Normal Sets the CAS bit to 1.
Forced Inverted Sets the CAS bit to 0.
DFXO to DFXS
CAS Bit Forced Normal Forced Inverted
A bit (fault) Sets the CAS A bit to 1
continuous fault state
Sets the CAS A bit to 0
no fault state
B bit (ring) Sets the CAS B bit to 1
no DFXS ringing output.
Sets the CAS B bit to 0
continuous DFXS ringing output.
C bit (billing) Sets the CAS C bit to 1
no DFXS billing tone output.
Sets the CAS C bit to 0
continuous DFXS billing tone output.
D bit (reversal) Sets the CAS D bit to 1
no DFXS polarity reversal
Sets the CAS D bit to 0
continuous DFXS polarity reversal
DFXS to DFXO
CAS Bit Forced Normal Forced Inverted
A bit (off hook) Sets the CAS A bit to 1
no DFXO off hook
Sets the CAS A bit to 0
continuous DFXO off hook
16. Click Apply to apply changes or Reset to restore the previous configuration.