User's Manual
Table Of Contents
- 1. Getting started
- 2. Introduction
- 3. Preparation
- 4. About the terminal
- 5. Mounting and installing the terminal
- 6. Connecting to the terminal
- 7. Managing the terminal
- 8. Configuring the terminal
- 9. Configuring the traffic interfaces
- 10. Cross Connections
- Embedded cross connect switch
- The Cross Connections application
- The Cross Connections system requirements
- Installing the Cross Connections application
- Opening the Cross Connections application
- The Cross Connections page
- Setting the terminal's address
- Management and user ethernet capacity
- Setting card types
- Getting cross connection configuration from the terminals
- Creating cross connections
- Sending cross connection configuration to the terminals
- Saving cross connection configurations
- Using existing cross connection configurations
- Printing the cross connection configuration
- Deleting cross connections
- Configuring the traffic cross connections
Configuring the traffic interfaces | 101
DFXO port settings
1. Select Link or Local or Remote > Interface > Interface Summary, then select the DFXO interface
and click Configure Interface.
2. Select the DFXO port to configure, and click Edit.
'Slot' shows the slot the DFXO interface card is plugged into in the terminal (A – H).
'Port' shows the interface port number (1-2).
‘PCM Mode’ shows the current mode assigned to the port by the cross connect.
‘Loopback’ loops back the port digital paths to return the port analogue signal back to the
customer.