User's Manual

Safety Requirements
To comply with Intrinsic Safety requirements, the following restrictions must be observed:
● This device must only be used by Trained Personnel, and with due consideration to
Intrinsic Safety requirements for use within hazardous areas.
● This device must not be modified in any way.
● Maintenance and repair must be performed by authorized Hawkiiii Technicians.
● This device must be operated only as described in Section 1.2.
● This device is supplied as a complete kit of certified Intrinsically Safe components. No
components may be replaced by uncertified parts.
● Certification labels must appear on the body of the device. Labels must not be removed
and must remain visible and legible.
● Certain variants of the Wireless Dynamometer are configured to interface with an RTU
(POC, PLC, etc.). This RTU Interface must be installed in a Class 1 Div 2 rated
enclosure while operating in a Class 1 Div 2 hazardous area.
Any violation of the above may compromise the Intrinsic Safety rating of this device.
_____________________________________________________________________________________
Wireless Dynamometer August 2018 User Manual | 5 of 22