CANopener Flash Owners Manual

4
CANOPENER FLASH | Owner’s Manual
2 Use & Operation
Insert
Simply insert the CANopener Flash into the OBD-II port. Although the placement changes slightly from
vehicle to vehicle, it will always be on the driver’s side, below the steering wheel. Sometimes there will
be a cover that must be removed by hand to access it.
Once successfully connected to the vehicle, you will see a blinking BLUE light while programming is in
progress.
Remove
The CANopener Flash will present a solid GREEN light, indicating that programming was successful or a
RED light if there was an error. In most cases, the module being programmed will reset. This might
manifest in a blank screen or abnormal behavior while the reset takes place - this is to be expected.
If you get a RED light (indicating an error occurred), consult the troubleshooting section of this manual.