Data Sheet

 USB 2.0 compliant Full Speed 12Mbps maximum speed.
 Hardware or Xon/Xoff handshaking supported; 300bps to 1Mbps.
 UART supports 5-8 bit data, 1-2 Stop bits, odd/even and no parity.
 Integrated EEPROM for Vendor ID, product ID, serial number, release number.
 Virtual COM port drivers allow operation with existing COM port PC applications.
 Supports Windows, MAC (OSX-9 and above) and Linux (2.4 kernel and above).
 USB powered; -40 to +85 deg C temp range.
 Small size; circuitry built inside the USB connector.
 1m in length
 RoHS compliant
Typical Applications
The 4D Programming Cable makes an easy USB to Serial interface, so you can easily create;
 Interface micro-controller UART to USB
 USB to RS-232 converters
 USB to RS-422/RS-485 converters
 Upgrade legacy RS232 devices
 Make PDA and cellphone USB interface cables
 Serial Interface for barcode readers, POS terminals, etc
The cable is designed specifically to interface directly with all 4D devices that use a 5pin programming
header. In any non 4D device application, make sure the TX and RX lines from the cable are crossed over
to the attached peripheral, that is, the TX from the cable connects to the RX of the target and the RX
from the cable connects to the TX of the target device.
Installation
Driver Installation - Windows
 Download the zip file from the link on the left, "Drivers for Windows", into a folder on your
system and unzip the file.
 Launch the application and follow the prompts given by the Install Wizard. This will copy all
necessary files to a destination folder provided by the install wizard.
 You will be advised to read the terms of the "Licence Agreement". If you accept then the
installation will proceed. Click "Next".
 Only change the "Destination Location" if there is a need to do so, otherwise accept the default
location. Click "Next".
 Now we are ready to install. Click the "Install" button to start the installation.
 When the "InstallShield Wizard Complete" window pops up you will need to select the tick box
for the "Launch the CP210x VCP Driver Installer” option. Select this and click the "Finish" button.