Quick Reference Guide

Choosing your Device Settings is very important.
Consider how you plan to deploy the Device, who
will be assigned to view information about the
Device and receive Alert Messages, how often
you want to receive information on the Device’s
location, whether it triggers on Motion or Ping,
and how long the battery needs to last.
Quick Reference Guide for ESO® GPS Products
Motion Sensitivity
The Device can be set to trigger on a variety of
continuous motion durations depending on how
it’s being used.
No Motion Reset
The Device can be set to stop activation and reset
after it has been motionless for various periods of
time.
(Geo) Fencing
A fence is a perimeter around an address. Once
the fence perimeter is broken by a Device entering
or leaving the perimeter, a text or email alert will
be generated.
Real-time Ping
If Real-time Ping is selected, the Device will
respond within moments of the Ping command
being sent. Note that Real-time ping will reduce
battery life.
Ping Reset
Users may Reset the Device via the Reset button
on the Map Page. If the Device is not manually
Reset after being pinged, it will continue tracking
until the battery is depleted.
A The Acve/Status Device Pane OR
B The Device List/Last Locaon Fix
Login to access and change Device information
or to track Device at 3sitracking.com.
Device Settings
Select the Device you wish to view/edit either via
Chirp
Users may send a command to an active device
causing it to emit a chirp sound. Chirping will
end after 10 minutes or upon the device receiving
a cancel command when the Cancel Chirp button
is clicked.
Beacon
The default setting for the Beacon is ON. If the
Hand Held Beacon Receiver is not required, the
Beacon can be turned off by selecting the Turn
Beacon Off button.
Hibernate
The Hibernate functionality allows the User to
place the Device into a non-responsive mode.
While in Hibernate mode, the Device will not
track on motion, report in for an interval setting,
respond to a ping command, trigger, or report
battery status alerts. Hibernate may be delayed
by scheduling to start at a future date and time.
Device Charging
The Device battery is charged using the charger
shipped with the Device. It takes approximately
two to three hours to fully charge the battery.
Low Battery Alert
The Device will send a low battery text or email
alert to the User designated to receive Device
alerts when the battery is 3.7V or lower.
Please reference the complete ESO User Manual
for detailed instructions.
Motion
The Device can be set to
track on Motion. When
Motion is selected, the
Device will automatically
begin tracking when
continuous motion is
detected.