User's Manual

Figure 5
7.0 Modify Currency Pressure Plate
Using a rotational cutter, modify the green plastic pressure plate (Figure 5).
Temporarily place the spray bar and bracket in place to assure that there is no
interference as the plate slides from from to back. The spray bar should be
positioned within a few millimeters of the currency position.
Figure 6
8.0 Prepare for Bracket Mounting Pad Installation
Place a small dot between the 20
th
and 21
st
tooth on the gear rack, both sides,
as shown in Figure 6. Thoroughly clean the area between the dotted white
lines with an alcohol wipe, both sides.
1
21
DOT
Clean Area
Octopus ATM Defense System
Installation and Operation Guide
Page H5