User's Manual

8.0 Clean Cassette Bracket Mounting area
Temporarily place the bracket assembly in the cassette, note where the three,
elongated, slotted mounting holes line up with the cassette sides. Remove the
Bracket Assembly and, (IMPORTANT)thoroughly clean the sides in the
noted area with the alcohol wipes.
Figure 5
9.0 Mark Location for Bracket Mounting Plates (3)
Place the Bracket Assembly into the cassette and set the distance between the
front of the bracket and the inside of the cassette front to 42mm Figure 5.
With the Bracket Assembly in place, mark a small dot in the center of each
elongated mounting slot, one on the left side of the cassette and two on the
right side, Figure 6
Figure 6
22mm
Page E5Octopus ATM Defense System
Installation and Operation Guide