User's Manual
26
Getting Ready to Build
PREPARING BUILD PLATFORM
Do not touch the extruder
tip or heated build platform
during Dremel 3D45 operation or until it
has cooled down to at least 60°C (140°F).
Contact with the extruder tip or build platform
during or after operation before tip and build
plate has cooled may result in personal injury.
Do not drop the build
platform. Tempered glass
plate may break and result in personal injury.
Do not remove tempered
glass plate from plastic
holder. Contacting with tempered glass plate
edge may result in personal injury.
Before every build make
sure that the build platform is
covered with glue from the supplied glue
stick. If glue is not used, it may cause poor
object build quality.
1. Remove build platform by first pressing
down and releasing the two clips located
at the front of the build platform, then lift
the build platform off the base using the
build platform tabs (figure 3).
2. For best results, apply a thin layer of glue
with the provided glue stick to the build
platform, figure 4.
NOTE: To clean the build platform, rinse
the platform with warm water and dry with
a towel.
3. Install the build platform by first inserting
the rear of the platform onto the rear clips,
then press down on the front of the
platform until it snaps in place.
FIG. 4
!
CAUTION
!
WARNING
!
WARNING
!
WARNING
Rear ClipRear Clip
Front Clip
Front Clip
Tab
FIG. 3
Tab
Base
Build
Platform
Glue
Stick
DM 2610047405 06-17_3D45 6/1/17 7:30 AM Page 26